Sign In   Register
Introduction
Pinned Items
Recent Activities
  • Paul 50 replied to the topic MG3 2020 in Technical - MG3
    Hi.
    If its anything like my 2015 model, the DLC is underneath the dash, drivers side near to the door.
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Paul 50 replied to the topic MG3 2020 in Technical - MG3
    Hi Witekl.
    My MG3 is a RHD version in the UK.
    The EOBD connector is under the drivers side dash near to the door.
    Hope this helps.
    Cheers.
    Paul 50.
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Paul 50 replied to the topic P0500 in Technical - MG3
    Thanks KevandAnna.
    I'll have to wait until it happens again (hopefully not) and carry out some further diagnosis.
    Unfortunately there isn't a lot of support for these cars out there apart from this forum.
    If it does happen again and I can diagnose it myself I'll put a post on here for anyone else.
    Apart from that the car drives well and is a joy.
    Cheers.
    Paul.
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Paul 50 created a new forum post in Technical - MG3
    Hi. Has anyone had an issue with the cruise control on the MG3?
    My 2015 model has an intermittent fault where the CC symbol flashes 3 times and the cruise control doesn't work. The engine speed on the display seemed to be working ok.
    This happened the other day and when I connected my scan tool I had the DTC P0500 vehicle speed sensor A.
    I went on a test drive monitoring the engine RPM and VSS but nothing seemed untoward.
    When I got back the fault had cleared itself. I checked the scan tool to see which wheel sensors were responsible for the information and found it was the two rear wheels.
    My assumption is that the signals from the sensors goes to the ABS module and from there the information is transferred to the display and the PCM.
    I haven't had any no comm issues and the car drives well. The MIL wasn't lit either.
    Can anyone tell me if my assumptions on the system are correct or is there another vehicle speed sensor that supplies information to the PCM? My wiring diagrams don't show any other vehicle speed sensor.
    My scan tool is a launch CRP129E which I must admit is not very good for the Saic MG as launch have told me Saic is not supported so I cannot see the ABS module.
    Thanks.
    Paul 50.
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Paul 50 unlocked the badge Newbie
    Newbie
    Being part of a community. To unlock this badge, you need to register on this site.
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Paul 50 just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.
© 2020 The-T-Bar.com All Rights Reserved.

Please publish modules in offcanvas position.