Sign In   Register
Introduction
Pinned Items
Recent Activities
  • Saverauto created a new forum post in Technical - MG6
    MG6 
    VIN # LSJW24G93HS021794

    New battery was installed into vehicle.
    Starter motor wouldn't turn over & car wouldn't start. Not too sure if starting issue occurred before or after battery replacement.
    Start/stop system malfunction warning appears on dashboard.
    Scanned vehicle ECM/ECU & found the following fault codes:
    14A9 - please refer to official manual
    14A8 - please refer to official manual
    Deleted fault codes & was able to start vehicle & drive it to a workshop.
    Started up again when moving vehicle in doors but now it won't start up again.
    Start/stop system malfunction warning active all the time now. Cannot delete fault codes anymore, faults are static.
    Scanned as generic OBDII:
    P14A9 - please refer to official manual
    P14A8 - please refer to official manual
    Please, does anyone know what these fault codes are for?
    Would anyone have an official manual that could describe these fault codes?
    Thanks in advance
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Saverauto unlocked the badge Newbie
    Newbie
    Being part of a community. To unlock this badge, you need to register on this site.
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Saverauto just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.
© 2020 The-T-Bar.com All Rights Reserved.

Please publish modules in offcanvas position.